[Mikep51]

I installed my old Blackvue DR650GW-2CH camera in my 2018 Pacifica.
It is powered from the 12V front power outlet on the bottom left of the dash.
When I use Remote Start, I notice the Camera does not power up, until I am in the van and press the keyless push button ignition to "Run".
Does anyone know of a power source or fuse that i could tap into that would send power to my camera when in Remote Start mode?
I can hardwire the camera if needed versus the 12V "cigarette lighter" power cord I am currently using.

Thanks!

 

[Jeremy M.]

There you can move fuse 95 from A to B that will give that outlet battery power 24/7.

 

[Mikep51]

Thanks Jeremy, but I don't think that would work for me.
I don't want the camera on 24/7. just when the remote start is activated.

 

[Jeremy M.]

You could use a cheap test light. Clamp one end to ground and probe around to find what powers up with the remote start.

 

[Mikep51]

yeah ill try that. i bought a USB tester to test the USB ports : )
thanks!

 

[jsearles76]

yeah ill try that. i bought a USB tester to test the USB ports : ) thanks!

Hey just saw this thread...trying to do the same with my aftermarket heated steering wheel. Any luck finding a workaround? Thanks

 

[stop-eject]

There are no fuses in the cabin, the fuse panel is in the engine bay.

 

[jsearles76]

yeah ill try that. i bought a USB tester to test the USB ports : ) thanks!

Mike, did you have any luck getting the 12v outlet to turn on when remote start is activated? Thanks