Engine won't start - brake and stability control errors

13472 Views 9 Replies 6 Participants Last post by ChryslerCares, Feb 24, 2020

b31berndt

Discussion Starter · Feb 23, 2020

My 2017 Pacifica engine will not start, but the panel and radio come on. I get two error messages, "Service Electronic Stability Control" and "Service Antilock Brake System". When I scroll through the vehicle information screens, the battery is showing low power (8.8V). Do I have a battery issue or should I be looking at something else?

Save

1 - 1 of 10 Posts

Waldo

· #2 · Feb 23, 2020

I'd certainly replace that battery first. There's a good chance it is causing the other two error messages. If you have ESS, check the condition of both batteries.

Save

Reactions: 2

1 - 1 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.