2017+ Chrysler Pacifica Minivan Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
I'm looking to remove the Chrysler emblem on my 2017 Pacifica and replace it with something a bit more superhero like. How do I do this? Is there an easy way? Walk through?

Any help would be appreciated...
 

·
Registered
Joined
·
20 Posts
Discussion Starter #2
I was able to figure out most of it, but had a hard time removing the emblem cleanly. Does anyone have a suggestion on how to cover the existing holes that are exposed?
 

Attachments

·
Super Moderator
Joined
·
727 Posts
I'm looking to remove the Chrysler emblem on my 2017 Pacifica and replace it with something a bit more superhero like. How do I do this? Is there an easy way? Walk through?

Any help would be appreciated...
Soooo, did you do walk through to help others?
 
  • Like
Reactions: bryman

·
Registered
Joined
·
20 Posts
Discussion Starter #4
I did not document it as I was rushing the weather and could not get the 2 internal screws out. Not a lot of finesse on this job....was looking for pointers from the community that might have already attempted this.
 

·
Registered
Joined
·
20 Posts
Discussion Starter #6
Did u have to remove front bumper do it from inside? or just use heatgun to remove it?
I did it from the inside. You remove the retainer clips around the shroud and there is enough room to put your hand back there. The emblem is held on by 3 tabs. I was able to push back on 2 of them but did not get it out without damaging the tabs. When it's time to sell it, Gorilla Glue will be my friend.
 
1 - 7 of 7 Posts
Top